I have a stacked Bar Chart in SSRS.
If a bar is below certain value how to change label of this bar to invisible?
For example if bar below 2,400,000 feet then label to invisible
Is this possible?
The bar labels have a visible property. But how to tell SSRS to decide on every x bar?
Related
Unable to reduce gap between bars of the same group in bar chart in SSRS 2016
I tried adjusting Point Width in custom attribute to 0.5 but it only reduces the width of the bar but not spacing between the bars. I have enabled data labels and there are some with zero data labels which has been configure to show as spaces. So I guess the space between the bars of the same group is because of the data labels which have been made to show as space. How do I make the bars of the same group close to one another.
I'm going nuts trying to control the label position for a barchart. I want the labels to be above the bars and it mostly works. For a large dataset, a couple of bars have the label inside the bar and the rest are all above. For a smaller dataset, the labels all are above. I can't find ANY combination of properties that work consistently.
Click on the series in your chart then on the right side where the properties are under Labels -> Position -> Change to Top.
This is my gantt chart build for SSRS 2008 R2.
You can see light gray vertical lines on the third row, but not on the other lines. This is because these lines are draw under the bar (green and orange). My request is, how to draw these lines (Grid Lines) over bars (green and orange)?
Each line in my Tablix is a chart of type "Range, Bar", but all are on the same time frame.
Thanks
Have you tried setting the ZIndex of the Bar and Range chart?
Highlight the chart hit [F4] and the setting will be at the bottom of the properties tab. Set the ZIndex of the Bar lower than Range.
For each bar, I would like to show the labels either
all above the bar
all below the bar
some other alternative way than just placing the number inside the rectangle
I am currently fiddling with the properties options with no success. Any advice would be appreciated.
I Create SSRS stacked bar chart using BIDS.Its look like,
Here,the group will shown in Vertical Axis and the Phase shown in Horizontal Axis.I need to Customize the horizontal Axis.
My question is,I dont want to show number like 10,20,30,40 instead of that I need Text for replace Number.
How to customize the Axis points?Existing:10,20,30,40,50 but I need to change like ,Expectation:Ten,twenty,thirty,Fourty
You can use bar chart with categories on the xAxis.